Panasonic CQR255SEUC - Manual (Page 25)

Motor Antenna
Connect the vehicle motor antenna lead to the blue
motor antenna relay control lead.
Battery
Connect the yellow battery lead to the correct radio
wire or to the battery fuse port on the fuse block.
Antenna
Connect the antenna by plugging the antenna lead
into the antenna receptacle.
Equipment
Connect any optional equipment such as amplifier,
according to the instructions furnished with the
equipment. Keep about 12 inches (30 cm) of dis­
tance between the speaker cprds/amplifier unit and
the antenna/antenna extension cord. Read the
operating and installation instructions for any equip­
ment you will connect to this unit.
Power
Connect the red power lead to the correct vehicle
radio wire or to the appropriate fuse port on the fuse
block.
If the stereo unit functions properly with all these
connections made, disconnect the wires and pro­
ceed to the final installation.
□ Final Installation
Lead Connections
Connect all wires, making sure that each connec­
tion is insulated and secure. Bundle all loose wires
and fasten them with tape so they won't fall down
later. Now insert the stereo unit into the mounting
collar.
Congratulations! After making a few final checks,
you’re ready to enjoy your new auto stereo system.
□ Final Checks
1. Make sure that all wires are properly connect­
ed and insulated.
2. Make sure that the stereo unit is securely held
in the mounting collar.
3. Turn on the ignition to check the unit for prop­
er operation.
If you have difficulties, consult your nearest autho­
rized professional installer for assistance.
□ Installation Procedures
Note: Disconnect the cable from the negative (-) battery terminal.
1. Secure the Mounting Collar 0.
Insert Mounting Collar ® into the car’s dashboard, and bend mounting tabs out with a screwdriver.
CQ-R255SEUC
25