Panasonic Combinatin VCR AG-513E - Manual (Page 23)

Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few
seconds to cancel the Timer
Recording.
• Any future daily or weekly recordings
will be performed as programmed.
f PQigu uccT im WiMW
0 O O O
[ Q O © © l
( s o C D ® ®
o©©<
o <£> b
: h \
^ Q
> © ^ '
ADD/DLT
SELECT/
SET
-^:CH UP
▼:CH DOWN
► :VOLUP
^:VOL DOWN
PROG
ACTION
STOP
Review, Repiace or Ciear Program
Contents : (Recording is not in progress)
1
Repeat steps 1 and 2 on page 22.
P DT START STOP CH SPO
8 10:00aie:00p125 SP
3 10 8:00p 9:OOp 10 SP
4 SU 9:00p10:00p L LP
CANCEL :ADO(DLT
SELECT 1-B:* »
ENTER >
END .PH0G/ACT1ON
Press AT to select
the desired program.
To Replace program...
1) Press ► to display.
2) Press AT to select
and press ^ or ^
to set new program
contents.
3) Press PROG
(or ACTION).
fsiLTEi/ start STOP C h ]
8 SAT 9:OOP12:OOA 08
ripilXtN
CATEGORY:MOV IE ABC
SP
SELECT:* r
SET ;< ►
END :PROGMCTION
To Clear program...
Press ADD/DLT.
P DT START STOP CH SPO
8 I0:00p12:00a125 SP
10 8r00p 9:00p 10 SP
SU 9:00p10:00p L LP
SELECT 1-8-* *
ENTER
END :PROG/ACTION
Press PROG twice (or ACTION)
to exit this mode.
• 2 minutes before Timer recording is performed, “PLEASE PREPARE FOR TIMER REC" appears
and/or the PROG TIMER Indicator Hashes. Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the lower numbered program will have priority.
• If the start time for a Timer Recording comes up during a normal recording or One Touch
Recording (page 14), the Timer Recording will not be performed.
• If there is a power interruption of more than one minute, the recording may not be performed or
continued.
• If “INCOMPLETE" appears after ail items have been set, check all entries and make necessary
corrections.
23