Panasonic AC Adaptor DE-852D - Manual (Page 5)

Supplying Power
AC Adapter
11nsert the battery-shaped connector
of the DC Input Cable into the Cam­
era Recorder.
2
Connect the other end of the DC In­
put Cable to the AC Adapter as shown.
3
Plug In the AC Adapter.
• The POWER Lamp of the AC Adapter
lights up.
• When the DC Input Cable is connected into the AC Adapter, the AC Adapter cannot
charge the Battery.
About the AC Adapter:
• When the Charge Lamp does not light, remove and then reattach the Battery. Or, attach
the Battery to the Camea recorder, use it for 10-20 minutes, and then reattach the
Battery to the AC Adapter.
• If it still cannot be charged, consult with your dealer.
• When the Battery is hot, charging takes longer than normally.
• If you remove and reattach the Battery during charging, the Charge Lamp may go off
momentarily while the AC Adapter is checking the change remaining in the Battery, but
this is normal.
• If you use the AC Adapter very close to a radio while listening to a broadcast (especially
in the AM range), the reception may be distorted by interference. Use the AC Adapter
more than 1 meter away from a radio.
• During use, the AC Adapter may emit some sound, but this is normal.
• After use, be sure to disconnect the AC Cable from the AC outlet. (If it is left connected,
approximately 1 W of power will be consumed.)
• It may take a short time before the AC adapter’s POWER Lamp lights, but this is normal.