beautypg.com

Before requesting service, All these things are normal, Problem – Panasonic THE GENIUS NN-R687 User Manual

Page 42: Possible cause remedy

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Before Requesting Service

^All these things are normal:

The oven causes

interference with my TV.

Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, blow dryers, etc. It does not
indicate a problem with your oven.

The oven lights dim.

When cooking with a power other than HIGH, the oven must cycle to
obtain the lower power levels. The oven light will dim and clicking noises
can be heard when the oven cycles.

Steam accumulates
on the oven door and warm
air comes from the oven
vents.

During cooking, steam and warm air are given off from the food. Most of

the steam and warm air are removed from the oven by the air which

circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.

I accidentally ran my

microwave oven without

\^ny food in it.

Running the oven empty for a short time will not damage the oven.
However, we do not recommend operating the microwave oven

without any food in it

)

PROBLEM

-

POSSIBLE CAUSE

REMEDY

.___________ -

Oven will not turn on.

The words “DEMO MODE”

appear on the screen.

Clock pad has been pressed three

times, or Function “6" was pressed.

When the oven is turning

on, there is noise coming

from the glass tray.

The oven is not plugged in

securely.

Remove plug from outlet, wait
10 seconds and reinsert.

Circuit breaker or fuse is

Reset circuit breaker or replace

tripped or blown.

fuse.

There is a problem with №e

Plug another appliance into the

outlet.

outlet to check if it is working.

,

The door is not closed completely.

Close the oven door securely.

Start Pad was not pressed after

^ programming.

Press Start Pad.

Another program entered
already in the oven.

Press Stop/Reset Pad to

cancel the previous program

and program again.

The program is not correct.

Program again according to the

Operating Instructions.

Sfop/Reset Pad has been pressed

. accidentally.

Program oven again.

Deactivate mode by pressing Clock Pad

three times, or clear Function.

- ' '

The roller ring and oven bottom

Clean these parts according to

are dirty.

-

Care of Your Oven (next page).

If you have any questions or it seems there Is a problem with the oven,

contact PANASONIC CUSTOMER SERVICE for assistance.

1-800-211-PANA (7262) (9 a.m. - 9 p.m., E.S.T, Toll Free)

-

40

-

This manual is related to the following products: