Panasonic OMNIVISION PV-8660 - Manual (Page 29)

•Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
If you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 28, you will need to complete the Cable Box Setup steps below.
2
3
4
#
5
Cable Box Setup
Complete this page only if Type A
connection method (pg.28) is used.
1
Press ACTION* to display ______________
the menu.
Press
AT
to select “SETUP
CHANNEL," and then press
► to display the “SET UP
CHANNEL” screen.
------------------ MENU --------------------
SET UP VCR
SET UP FEATURE
SET CLOCK
SET UP CHANrjEL
IDIOMA/ LANGUE: ENGL 1 SH
SELECT
SET
END
A ▼ KEY
► KEY
ACTION KEY
Press
AT
to select “CABLE/
DSS BOX SETUP,” and
then press ► to display the
“SELECT HOOKUP” screen.
------- SET UP CHANNEL
ANTENNA : CABLE
AUTO SET
CHANNEL CAPTION
VCR PIUS+ CH SET UP
SELECT:^ Y KEY
SET :► KEY
END :ACT I ON KEY
m
Press
AT
to select your hookup,
and then press ^ to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue with step 5.
If not, press ACTION three times
and turn to page 30.
SELECT HOOKUP
CABLE/DSS BOX»VCH»TV
VCRYCABLE/DSS BOX^TV
VCR^TV
SELECT:A ▼ KEY
SET :► KEY
END
:ACT I ON KEY
Press
AT
to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudtoA/ideo jack
connections to your cable box,
select and set “VIDEO OUT" as
the output channel.
SELECT HOOKUP
CABLE/DSS BOX^VCR^TV
CABLE/DSS BOX OUTPUT CH
SELECT
SET
END
A ▼ KEY
•* ► KEY
ACTION KEY
6
Press ACTION twice to end the setup and return
to the normal screen.
Go directly to “VCR Plus+ Programming” on page 31.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
29