Panasonic OMNIVISION PV-8660 - Manual (Page 14)

On-Screei^isglay^OSD)
‘Important: If the remote control POWER, ACTION, PROG, CHA/V, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
{Some Station names may
also appear if Channel
Caption is set. See page 20.]
Menu Screen
1 Press ACTIONMo
display the menu.
2 Press AT and ► to
make your selection.
SET UP VCR
SET UP CHANNEL
ЮIОМА/LANGUE:ENGLISH
SELECT:* ▼ KEY
SET :► KEY
END : ACT I ON KEY
To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Function
Status
Rec Time
Remaining
(OTR mode only
see page 17.)
Current Time
Channel Caption
(See page 20.)
Counter
Broadcast Audio
Being Received
(See page 26.)
• This display will
disappear in 5 seconds.
Tape Speed
(See page 5.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Blue Back ON/OFF
Feature (page 21) set to ON, the TV screen will
turn solid blue.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 12.)
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
After a Timer Program has
been set...
(See page 18.)
If you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 16.)
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 15,16)
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 19.)
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
If you press a function button
other than STOP/EJECT or
POWER on the VCR, or STOP
or EJECT or POWER on the
remote control while the VCR is
in VCR Lock mode...
(See page 22.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
TUBN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
CHECK CASSETTE
RECORD TAB
N0 CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END;PLAY KEY
VCR LOCK ACTIVATED
14