Panasonic RX-FT570 - Manual (Page 5)

You can use normai tapes only.
You can use either deck 1 or deck 2 for tape playback by
following the same steps. (This page shows an example
using deck 1.)
Single tape playback E
i li" I Set SELECTOR to TAPE/gaa .
----
TAf e GD HADQ j^iLINl
* I i
y BsTOP/EJECT Press STOP/EJECT, and then
^ ' I insert the tape.
Insert the cassette with the
exposed tape facing up.
Playback side
REV MODE
4 <>PUY
№Pri>CEOU.LIZtA
Set REV MODE (For deck 1 only)
to select desired playback mode
in deck 1.
*-3 : Two side playback mode
3L q±> : Repeat two-side playback
mode
Press PLAY to start playback.
Adjust VOLUME, GRAPHIC
EQUALIZER and XBS level con­
trols as desired.
To stop the playback:
Press STOP/EJECT.
Auto stop:
During playback, when the tape reaches its end, the auto­
matic stop system will release PLAY and automatically turn
the unit off. During tape playback, if the deck 1 REV MODE
is set to " position, the automatic stop system does not
function.
When the tape reaches the end by pressing FAST, the auto­
matic stop system does not function. The tape will stop, but
as the motor continues to turn, do not leave the set in this
condition. Be sure to press STOP/EJECT.
To fast forward or rewind the tape UI
Deck 1
Press -«4 -FAST-►► while the tape is stopped.
Deck 2
Press -44/CUE or ^/REV while the tape is stopped.
The tape will start moving forward or reverse direction at
high speed. To stop the fast forward or rewind operation,
press STOP/EJECT.
Note;
Do not press PLAY during fast forward or rewind, as this
may jam the tape. Always press STOP/EJECT first between
functions.
To cue or review the tape 0
For deck 2 only
During playback, press and hold <4/CUE or >^/REV.
The recorded sound on the tape can be monitored at high speed.