Set selector to radio, Set band to the desired radio band, Use tuning to tune into a desired broadcast – Panasonic RX-FT570 User Manual

Page 4: Listen^ io éadw bro€bdcàst

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Listen^ io Éadw Bro€bdcàst$

le 1111 II

Set SELECTOR to RADIO.

Set BAND to the desired radio
band.

FM STEREO: To receive FM

stereo broadcasts

(if you have tuned
into an FM stereo
broadcast, the FM
indicator wiil light.)

AM:

To receive AM

broadcasts

if FM stereo reception is poor, set BAND to FM. This

will reduce the noise and provide ciear reception:

however, the broadcast wiil not be heard in stereo.

Use TUNiNG to tune into a
desired broadcast.

Adjust VOLUME, GRAPHIC

EQUALiZER and XBS.

iCliitLMOCHl nw

The radio can be turned off by setting SELECTOR to TAPE/

XBS (extra bass system)

When the XBS button is set to "ON”, the dynamic low fre
quency ranges are boosted. Adjust the level by using the

XBS level control. Using this system with graphic equalizer

helps you

to get more dynamic

sounds.

Graphic Equalizer

It allows you to edit the frequency response of the unit to
compensate for room acoustics and other factors which
affect frequency response. The overall tone can be altered
by adjusting the controls at the three frequency bands;

100Hz, 1 kHz, 10 kHz.
For increased amplification of the corresponding frequency

band, position the switch towards “+10” marking and like
wise towards the “-10" marking to attenuate the correspond
ing frequency band.

If the XBS button is set to “ON”, the 100 Hz control functions

as the XBS level control.

Adjust the antennas

FM;

Pull out the telescopic antenna and adjust its length and

angle for optimum reception.

AM:

Turn the unit in the direction which gives the best results.