Panasonic CF-VDD723 - Manual (Page 9)

Using the Drive in the MS-DOS Mode
To use the drive in the MS-DOS mode, configure the drive following the steps below after
performing the preparations page 7). If the steps listed below are performed with­
out completing the preparations first, the drive will not operate properly.
y Click the [Start] button then select [Shut Down],
^ Select [Restart in MS-DOS mode] and click [OK].
3 Open the “CONFIG.SYS” file for editing by issuing the following commands:
cd\( Enter I
edit config.sys C Enter I
4 Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters
“rem” at the beginning of the line. {Deleting “rem" causes the item to become valid.)
DEVICEHIGH=C:\WlNDOWS\COMMAND\OAKCDROM.SYS /D:MSCDOOO
(If this line is missing, add it.)
5 Press( Alt ] -f( F ) . thenC^ to save the file. Then press ( Alt ) +C F ). thenC X ] to
exit the Edit program.
6 Follow the same steps to edit the “AUTOEXEC.BAT’ file,
edit autoexec.bat ( Enter)
7 Move the cursor to the line containing “MSCDEX.EXE” and delete the characters “rem”
at the beginning of the line. (Deleting “rem” causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMANDVMSCDEX.EXE /DiMSCDOOO /L:L
(If this line is missing, add it.)
3 Press ( Alt ) +CHD , thenC S )to save the file. Then press CliD+CD , then CD to
exit the Edit program.
9 Restart the computer.