Panasonic KXT1418 - Manual (Page 8)

Pickup Remote Control
The Pickup Remote Controller produces a chirping sound in operation, and the answering machine
responds to the Controller with a beep.
Push the buttons on the Controller continuously, until the beep is heard through the telephone line from
the answering machine.
n
1
To Set the Answer mode Playback Messages
If you forgot to set the Answer mode:
To set
DIALTHEPHONENO. WAITFOR
TO WHICH THE UNIT 15 RINGS
IS CONNECTED
•The unit will play back the outgoing
message and then you may hang up the
Toll Saver
Set the Ring Selector to “Auto”;
If you call from a remote location and the unit
does not pick up on the third ring, hang up.
This means no calls have been recorded and
you will not be required to retrieve and pay toll
charges.
•Pick-up on At least one message
has been recorded. the second
ring:
•If does not
pick-up
on the
third ring:
After you have played back all the
messages from remote phone;
No messages have been
recorded. So hang up.
»Pick-up on
the second
ring in the
next call:
At least one new message
has been recorded.
• If no pick-up occurs on the third ring, no
messages have been recorded.
Dial the telephone number to which the
answering machine is connected.
While the Outgoing Message is playing,
place the Controller's speaker against the
telephone mouthpiece and push the Play
Back Button.
•One beep will sound then another beeps
will sound to tell you the number of
recorded messages, up to 8 times.
•The unit will rewind with voice and play
back all the recorded incoming messages
automatically, even at tape end.
•3 beeps will be heard after the last
message.
Hang up.
•Future incoming messages will be
recorded after the most recently recorded
message.
Remote Reset
To record the future incoming messages
from the beginning of the tape.
•After the recorded messages are played
back or while they are playing;
1 Push the Playback/Reset Button again.
7 -
2 Hang up.