Panasonic KXT1418 - Manual (Page 3)

Preparation
1
Push the power switch on.
• Power Indicator will light.
2
Insert
I
and | ^ | , and then reset the OGM tape by pushing the OGM START/STOP
button.
•Wait until In Use Indicator goes out.
3
Select each selector.
^® CPC switch---------------------------------------
Set to “A”.
Usually set to “A”.
(No call waiting service line)
Set to “B” when your line has call
waiting service.
Or if some incoming messages are
incomplete.
(J4) Recording Time Selector —
1 MINUTE;
•The unit will record up to 1 minute.
VOX:
•The unit will record for as long as the
caller speaks.
r
@ Ring Selector
2 :
•The unit will answer the telephone
on the second ring,
4:
•The unit will answer the telephone
on the fourth ring.
AUTO:
•The unit will answer on the second
ring if any incoming messages
have been recorded,
•The unit will answer on the fourth
ring when no incoming messages
have been recorded.
Battery Installation for Remote Controller
1 Open the Battery Compartment cover as
shown below.
2 Insert “AAA" size batteries (UM-4 or
equivalent) observing correct polarity {plus
and minus).
3 Replace the Battery Compartment cover.
Notes;
•If the Pickup Remote Controller is not to be
used for a long time, remove all the
batteries to prevent possible damage.
•The battery life is about one year for average
usage.
•When the sound from the Pickup Remote
Controller becomes weak, reolace all the