Panasonic KXT1418 - Manual (Page 5)

Setting Prior to
Leaving
The unit will automatically set to the Answer
mode by simply pushing the Power Switch.
When the telephone rings, the unit will play
back the OGM, then it will record the Caller’s
messages on the ICM tape.
Preparation
After reviewing the Outgoing or Incoming
message the unit will automatically reset itself
to the Answer set position and will be ready to
answer the next call.
After reviewing, the Answer/Call indicator
lights.
To record future messages after
the last message.
Leave the unit as it is. D
To record future messages from
the beginning of the tape.
Push the REW button.
When you use a new ICM tape or record
future messages from the beginning of the
tape, push the REW button.
Confirm that the Answer/Call indicator light
is on.
If you do not want to set the unit to the
Answer mode, push the Power Switch to off.
Listening to
Messages
When an incoming message has been
recorded, the Answer/Call indicator will flash
in group. Each group indicates the number of
incoming messages up to 15 (i.e. Three flashes
followed by a pause means that 3 messages
were received).
In the case of a power interruption, the Answer/
Call indicator will flash slowly after the power is
restored.
To Listen to Messages
Push
Pl_ AY BACK / PA USE
Auto-Logic (One Touch Operation)
ICM tape will automatically rewind and begin
to play back. At the end of all the messages 3
beeps will be heard.
7 seconds after the 3 beeps are heard the unit
will reset back to the Answer mode.
•Future incoming messages will be
recorded after the last message. To
record from the beginning of the tape,
push the REW button.
To Stop the Tape
Temporarily
1 ^ PI_AYBACK /PAUSE
Push
•The In Use Indicator will flash.
•To release, push it again.
•While in the pause mode, the unit will not
change to the Answer mode.
To Rewind (Fast Forward)
the Tape
1 r|) □ (c=i]
■ M|Jjr «4 nEW I FF ^ j
Push
•To release, push the Playback/Pause
Button again.
4 -