Panasonic CQ3700EU - Manual (Page 13)

Alarm Time Setting
(?)Keep holding ALARM until you have set the alarm time,
“ AMI2:00 ” blinks indicating the time setting mode is
activated.
To set hours, press "
To set minutes, press “
(Hold " \44 " or " " to change numbers rapidly.)
(2)When you have set the alarm time, release ALARM.
Note: When the alarm is not set yet, "AdJ" is displayed.
Resetting the Alarm Time
When you want to reset the alarm time, repeat step(T)to{2)above.
Alarm Operation
® Alarm is switched to ON or OFF each time ALARM is pressed.
©When the Alarm is switched to ON, the alarm sound will activate at
the set alarm time.
Turning off the Alarm Sound
The alarm sound will turn off automatically after 90 seconds. Otherwise,
press ALARM once.
Alarm output Volume Select
You may select ALARM VOL 1 (or VOL 2) by pressing ALARM.
• VOL 1 is lower than VOL 2
• OFF ^ VOL 1
t_______
VOL 2
R » .
L I ftiOt I
CAUTION:
• Be careful not to set wrong alarm time, otherwise, the alarm may
sound while driving.
• If the alarm is set, be sure to check the set alarm time by pressing CLK,
• If you operate the radio, etc. at the time set the alarm, the alarm
sound may be muted.
• If Volume is set at “0" step, the output volume will be muted. (Even
when ALARM is acting.)
CQ-3700EU
13