Connecting the control unit, Connecting the power cable, Connecting a speaker system – Yamaha disklavier Mark II XG Series User Manual
Page 13: Connecting other equipment, Power on procedure, Set the mains switch to on, Chapter 3 setting up your disklavier
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 3
Setting Up Your Disklavier
Set up your Disklavier in the following order.
Connecting the Control Unit
Make sure that the control cable extending from the piano is connected to the TO CONTROL CABLE FOR
PIANO connector on rear of the Control Unit.
Note:
The control cable should have been connected to the Control Unit when the Disklavier was
installed. If, however, it was not, carefully connect the control cable to the Control Unit’s TO
CONTROL CABLE FOR PIANO connector on the rear panel. See step (4) in “Mounting the
Control Unit to the Grand Piano” in the front of this manual.
The Control Unit may be placed on any stable surface on, neai; or away from the Disklavier as far as the
length of the cable will permit.
For the Disklavier grand, the Control Unit may be mounted to the underside of the treble side key bed. See
“Mounting the Control Unit to the Grand Piano” at the front of this manual.
Connecting the Power Cable
Connect the Disklavier’s power cable to an AC wall outlet.
Important: Make sure that the voltage of the AC wall outlet matches that marked on the Disklavier's
Serial No. plate.
Connecting a Speaker System
To enjoy Ensemble songs, connect powered speakers to the Disklavier’s OUTPUT terminals, as shown on the
next page. You can also use a separate amplifier with speakers. If your sound system is mono, use only the
L/MONO connector for the best sound.
12
Chapter 3 : Setting Up Your Disklavier
These are powered
speakers with built-in
amplifiers
(not supplied)
Connecting Other Equipment
To connect MIDI instruments to the Disklavier, see Chapter 8 “The Disklavier & MIDI” in the
Advanced
Operation Manual.
To connect a computer to the Disklavier, see Chapter 9 “The Disklavier & Computers” in the
Advanced
Operation Manual
Power On Procedure_____________________________________
Set the MAINS switch to ON.
Press the [STANDBY - ON] button on the front panel of the Control Unit.
The following message appears on the display.
.
.
.
.
.
.
.
.
t
J,***. 1. .1 I.”’. t
ri.-'M r'i! ! T !!!!'!"!'
Connecting Other Equipment
13