Connectors, Input connectors, Note – Yamaha AM802 User Manual
Page 7: Aux snd jacks, D aux rtn jacks, Phones jack, Rec out l and r jacks, St out l & r jacks, Important notes, Controls & connectors
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS & CONNECTORS
CONNECTORS
® INPUT Connectors
The AM802 has a total of 8 input channels, each of
which has a single 1/4" monaural phone INPUT jack.
See “ 1 . MIC/LINE Switch” for a description of the
MIC/LINE switches associated with INPUT jacks 1
through 6. When a MIC/LINE switch is set to MIC, the
input level and impedance for that channel are set to
-50 dB/50—600 ohms. When set to LINE, the input
level and impedance are -10 dB/600 ohms. The input
level and impedance for INPUTS without MIC/LINE
switches are -10 dB/600 ohms.
NOTE: ----------------------------------------------------
Since channels 7 and 8 are designed to handle
stereo signals, they have two input jacks each (L
and R) rather than the single input, jacks provided
on all other channels.
® AUX SND Jacks
These jacks deliver the AUX 1, AUX 2 and AUX 3
mixes, respectively, to feed an external signal proces
sor, performer’s headphone cue system, a monitor
system, etc. Nominal output level and impedance of
the AUX send jacks are -10 dB/10 kohms.
The output from signal processors fed by the AUX SND jacks can be returned to the master stereo buss bility with the wide range of mono-in/stereo-out signal the output from signal processor to the stereo buss. Nominal input level and impedance are -20 dB/600 ohms. ® PHONES Jack The PHONES jack delivers the mixer’s master stereo headphones. The PHONES control adjusts the head ® REC OUT L and R Jacks These output jacks are primarily intended to feed the ing, although they can be used to feed other audio REC OUT L and R jacks is controlled by the REC OUT control in the mixer’s master section. ST OUT L & R Jacks The main outputs from the mixer’s stereo buss. These 1/4" monaural phone jacks deliver the stereo buss signal at 0 dB, 10 kohms (nominal). IMPORTANT NOTES MAKE SURE THE MIXER’S POWER SWITCH IS OFF OR THE STEREO FADERS ARE SET TO MINIMUM ALWAYS TURN THE MIXER’S POWER ON OR RAISE THE MASTER FADERS AFTER TURNING ON CON NECTED SOURCES SUCH AS ELECTRONIC INSTRUMENTS, ETC. NEVER CONNECT THE SPEAKER OUTPUT OF ANY AMPLIFIER TO THE MIXER’S INPUTS UNLESS A SUIT ABLE HIGH-LEVEL ATTENUATION PAD OR “DIRECT BOX” IS USED TO LOWER THE SIGNAL’S LEVEL. 5 -
via these jacks. Stereo AUX RTN jacks offer compati
processors currently available. The AUX RTN jacks
can also be used to add external signals other than
program signal to a pair of standard 8 ohm stereo
phone monitoring level.
AM802 master stereo signal to a tape deck for record
equipment if required. The output signal level at the
WHEN CONNECTING OR DISCONNECTING ANY CABLES.