A warning, Installation hardware, Overview – Panasonic Removable Full Front CD Player/Receiver with Dot Matrix and CD Changer Control CQ-DFX983U User Manual
Page 50: Required tools, Dashboard specifications, Installation guide
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installation Guide
A WARNING
This installation information is designed
for experienced installers and is not in
tended for non-technical individuals. It
does not contain warnings or cautions of
potential dangers involved in attempting
to install this product.
Any attempt to install this product in a
motor car by anyone other than a quali
fied installer could cause damage to the
electrical system and could result in se
rious personal injury or death.
□ Installation Hardware
No.
Item
Diagram
Q’ty
©
Mounting collar
1
©
Hex. nut (5 mm^)
1
Rear support strap
1
©
Tapping screw
(5 mm0x16 mm)
1
Mounting bolt (5 mm0)
1
©
Power connector
1
©
Removable face plate
case
1
©
Trim plate
1
©
Lock cancel plate
2
□ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The in
structions in these pages will guide you through the
remaining steps:
(Please
refer
to
the
“WARNING”
statement
above.)
• Identify and label the car wires.
• Connect the car wires to the wires of the power
connector.
50
CQ;
d
F,X9837DF,903U
• Install the unit in the dashboard.
• Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution:
• This unit operates with a 12 V DC negative
ground auto battery system only. Do not at
tempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the items
which are packed with your unit.
• Warranty Card.
..Fill this out promptly.
• Panasonic Servicenter List for Service Directory
...Keep for future reference in case the product
needs servicing.
• Installation Hardware.
..Needed for in-dash in
stallation.
□ Required Tools
You’ll need a screwdriver, a 1.5 V AA battery, and
the following:
12 V DC
Electrical
Side-cut
Test bulb
tape
pliers
□ Dashboard Specifications
Thickness Min.
У\4'
{4.75 mm)
__.Ц._ Max. Уэг" (5.56 mm)
W
1
2Vzf
(53 mm)
,7Уз2"(182тт)