Set up features, Geomagnetic corr (correction), Tilt adjustment bar – Panasonic CT-3696VY-1 User Manual
Page 42: Input select, Auto power on
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Set Up Features
iHefpfùlfiHmts:
Setting PC Mode Set Up Features will also change
TV Mode and DTV Mode Set Up Features.
Auto Power On
- This feature automatically
turns the monitor ON when AC power is applied.
1. Press .
2. Press
A
or and or to select the Set
Up Icon.
3. Press ibszj] to display the Set Up menu.
A U T O P O W E R O N
GEOMWGNEiTilC
^SGB_
NOTE:
Setting the Auto Power On feature will cancel
the time and timer control setting. Also, the TV Mode
Main Menu Icon for the Control will be replaced with an
Exit icon.
4. Press A or ^ to highlight AUTO POWER ON.
5. Press or ^ to select SET
6. Press
twice to exit menus.
Geomagnetic Corr (Correction)
This monitor incorporates a special adjustment feature
for the convenience of the customer. This adjustment is
preset at the factory. However, adjustment may be
required when the monitor is moved (due to the
influence of earth’s magnetic field) which may cause
the picture to tilt slightly. If necessary, follow these
procedures to adjust the tilt.
1. Press .
2. Press A or ^ and or ^
or
Set Up Icon.
and ^ or to highlight the
3. Press
to display the Set Up Menu.
A UjTOlROlWE RiO.N
G E O M A G N E T I C C O R R
13^
4. Press
A
or ^ to highlight GEOMAGNETIC
CORR.
5. Press or ^ to display the Geomagnetic
Correction adjustment menu.
tilt adjustment bar
6. Press or to adjust the picture tilt until left
and right side of tilt adjustment bar is parallel to the
bottom of picture frame (if necessary).
NOTE: Discoloration may be visible in picture
corners if tilt bar is not parallel to the
bottom of picture frame.
7. Press twice to exit menus.
Input Select
This feature is used to select PC Input Front or PC
Input Rear for the monitor Input signals.
1. Press
2.
Press
A
or
w
and or to highlight the
Input Select Icon.
Press ^3) to display the Input Select Menu.
3.
4. Press or ^ to select FRONT or REAR.
NOTE:
PC Front or PC Rear can also be selected by
pressing the Input button while input Select
menu is displayed.
5. Press
twice to exit menus.
- 4 2 -