Panasonic CT-3696VY-1 - Manual (Page 23)

Geomagnetic Corr (Correction)
This monitor incorporates a special adjustment feature
for the convenience of the customer. This adjustment is
present at the factory. However, adjustment may be
required when the monitor is moved (due to the
influence of earth’s magnetic field) which may cause
the picture to tilt slightly. If necessary, follow these
procedures to adjust the tilt.
1. Press ^3).
2. Press A or and or ^ to highlight the
Set Up Icon.
Set Up Features (cont’d.)
3. Press to display the Set Up menu.
4.
5.
Press ^
CORR.
or to highlight GEOMAGNETIC
or ^
6
.
Press or to display the Geomagnetic
Correction adjustment menu.
Press A or ^ to adjust the picture tilt until left
and right side of tilt adjustment bar is parallel to the
bottom of picture frame (if necessary).
NOTE: Discoloration may be visible in picture
corners if tilt' bar is not parallel to the
bottom of picture frame.
7. Press
tilt adjustment bar
twice to exit menus.
Mode
IMPORTANT NOTE: The proper input mode must
be selected for the type of signal at the antenna
input.
• TV is used when the television is not connected to
a Cable TV System, for example, when using a
VHF/UHF antenna (Channels 02-69).
• CABLE is used when the television is connected to
a Cable TV System and when not using a Cable
Box (Channels 01-125).
NOTE: Some Cable TV Systems encode (scramble)
program material on specific channels. A cable
company supplied decoder is required to
reproduce an acceptable picture. Certain
Cable TV Systems offset some channels to
reduce interference. It will be necessary to use
the cable company supplied converter to
receive these specific channels.
1. Press fau) .
2. Press
A
or and or ^ to highlight the
Set Up Icon.
3. Press iteJ to display the Set Up menu.
4. Press
A
or to highlight MODE.
5. Press ^ or to select TV or CABLE.
6. Press twice to exit menus.
-
23
-