Lines, Connect your computer to a power outlet, First-time operation – Panasonic TOUGHBOOK CF-37 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

First-time Operation

Latches

@ Position the cover so that the edge of the cover is aligned with the lines of the

computer.
Then, while lightly pressing down on the center of the cover (with suppressing the back

of the computer by one hand), gently slide the cover until it snaps into place.

ireful not to get your fingers caught in the cover.

Lines

^Connect your computer to a power outlet

Be sure the AC adapter is connected until completing Step 7on page 11.

Handling the AC adapter

• Do not twist or pull the AC power cord forcefully. Doing so may damage the

connections.

• Use only the specified AC adapter with your computer. Using an AC adapter

other than the one supplied might damage the battery and/or the computer.

• When the DC plug is not connected to the computer, disconnect the AC cord

from your AC wall outlet.

• Problems such as sudden voltage drops may arise during periods of thunder

and lightning. Since this could adversely affect your computer, an
uninterruptible power source (UPS) is highly recommended unless the battei^
pack is installed.______________________________________________________ ^

Open the display (o=page 15) and turn your computer on

Slide the power switch and hold it for approximately one second until the power

indicator (ф) turns on before releasing it.

• After confirming that the power indicator has turned on, do not touch the

power switch until Windows setup has started.

• Once the computer is powered off, you must wait at least ten seconds before

powering it on again.

моте

The power saving function is factory set, so if there is no input from the key
board, touch pad, or external mouse for two minutes, the LCD is powered off

(ECO modeO'lj^^fi^^® "Computing on the Road" )*.

In the ECO mode the LCD will resume operation when the touch pad is used, or

when a key or the touchscreen is pressed.
The computer may enter the ECO mode while Windows is setting up or even
when an application software is being installed. In this case, because it is con
ceivable that a selection dialog box will be shown, for resuming from the ECO

mode, do not press C Enter) which may trigger a selection, instead, press a key
unrelated to the direct triggering of a selection, likeC CtrOkev.

* This excludes a pointing device connected to the USB port, e.g., a USB mouse.