Panasonic SA-AX6 - Manual (Page 4)

I
wi
s
1
polarities (®, ©).
Concerning fhe remote control
mm
o Thoroughly clean the battery compartment before inserting new
batteries.
® Do not mix o!d and new batteries, or batteries of different types
(carbon and alkaline, etc.).
® If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
® Do not use rechargeable type batteries.
© Do not attempt to recharge alkaline or carbon batteries.
9 Always remove old, weak or worn-out batteries promptly and dis­
pose of them properly.
9 Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
® If the leaking electrolyte comes into contact with skin or clothes,
flush with water immediately.
When you need to replace these batteries
Use two R6/LR6, AA, UM-3 batteries.
Remote control signal sensor
^0 ooa ó(^ ( 1 o
Ok OGQOOCO
SO® 00000=5 1 1 o o o o ©
Transmission
window
oooo
oooo
‘o CD O
o Q o
oao
o O o
oo o
Avoid any obstacles
About 7 meters in front
of the signal sensor.
(The actual range will
depend on the angle at
which the remote control
is used.)
m
Be sure the transmission window and the signal sensor are free
from dust. Excessive dust might effect performance.
The operation may not be correct if direct sunlight or other strong
tight source strikes the signal sensor of this unit. If there is a prob­
lem, place the unit away from the light source.