Panasonic CY-M9054EN - Manual (Page 13)

Fuse
Be sure to use a fuse of the specified rating (20A x 2) when repiacing a blown fuse. Fuses with higher capacity
ratings, use of any substitute, or connection without a fuse may result in a fire hazard or damage to the unit. If
the replacement fuse fails, consult your nearest authorized Panasonic Service Center.
Maintenance
To clean the exterior of this unit, use a soft cloth to wipe the surface. Do not use benzine, thinner, or any other
type of solvents.
Specifications
Power Supply
Current Consumption
Speaker Impedance
Power Output {“EIA” Power)
Maximum Power Output
Total Harmonic Distortion
Low Pass Filter
BASS Boost
Signal to Noise Ratio
Frequency Response
Input Sensitivity (Pre)
Input Impedance
Dimensions(W x H x D)
Weight
: DC 12 V (11 -16 V)
Test Voltage 14.4V
Negative Ground
: 24 A (at 45 W x 4)
:4a
: 2-CH; 90 W x 2 (20 Hz - 20,000 Hz, 0.08 %)
3- CH; 45 W X 2 + 90 W (20 Hz - 20,000 Hz, 0.08 %)
4- CH; 45 W
X
4 (20 Hz - 20,000 Hz, 0.08 %)
: 2 - C H ; 2 0 0 W x 2
3 - C H ; 1 0 0 W x 2 - k 2 0 0 W
4 - C H ; 1 0 0 W x 4
: 0.08% (1,000 Hz, at 45 W)
40 Hz - 400 Hz
0 dB -14 dB (Middle Frequency : 60 Hz)
: 1 0 5 d B (IHF,A)
: 10 H z - 4 0 k H z
: 0 . 1 5 - 4 V
: More than 10
k a
: 234
X
55.5 x 352 mm
:3.7 kg
Note:
Specifications and the design are subject to possible modification without notice due to improvements.
13