Leica Geosystems GPS System 500 Equipment - User Manual User Manual

Page 19

GPS Equipment User Manual - 4.0.0en

Getting started with the new Survey equipment

Measuring with the default configuration, continued

Now all required settings for a static
survey are made. The Survey \ Begin
panel looks as follows:

Press F1 CONT to finish this start-up
sequence.

Step 5: Logging raw data

We are now within the main Survey
panel. After the above configuration
setup, the main Survey panel will
look as follows:

Now press F1 CONT to confirm the
selection of the newly created job.

Finally you have to select the an-
tenna type and and antenna setup
which you are using. Normally this
will be AT502 on tripod (or AT501 on
tripod in case of a SR510 sensor).

This selection is made in the usual
way: first use the cursor down key to
get this input field highlighted. Then
use the cursor left or right key to
toggle between all available types
until the right one appears. Alterna-
tively you can press the ENTER key
to get a listbox from which the choice
can be made.