Dynon Avionics FlightDEK-D180 Pilots Users Guide - Manual (Page 81)

Alerts
8-2 FlightDEK-D180 Pilot’s User Guide
by the label “THIS.” Alert messages sourced from another Dynon product are preceded by the label “DSAB.”
Pressing SILNCE or ACK on any unit in the system silences or confirms the alarm on all units in the syste
Refer to the
m.
FlightDEK-D180
stallation Guide for more information on installing and configuring a DSAB system
DSAB Alerts section below for detailed DSAB-specific alerts. Refer to the
In
If installed, either the HS34 or AP74 (but not both) can be configured to output EMS, EFIS, and AOA alarm
information with tones (such as with direct audio connections to the EMS and EFIS), or via spoken voice alert
When configured for voice alerts, the HS34 reads out an alarm that occurs, such as “CHT 1 HI
s.
GH” or “LOW
ese voice alarms can be acknowledged and silenced just like the EMS tone.
er, a
ing the alarm indications active,
or alarm indications and return to your original screen.
T E button.
u press ACK the alarm text for the next posted alarm is
ssing ACK does the following:
FUEL.” Th
SHOW PAGE
If the alarming measurement is not displayed on your current screen, or is available on a page which displays it bett
SHOW [PAGE] button is included in the alarm menu. [PAGE] is replaced with the name of the actual page that is
displayed when you press the button. Press this button to display the page where the alarming measurement is best
displayed. From there, you may press GO BACK to return to your original screen, leav
press ACK to remove the
ALARM SILENCING
o silence the audio alarm, press the SILNC
ALARM ACKNOWLEDGEMENT
To acknowledge the alarm, press the ACK button. The ACK button has a number next to it indicating the number of
currently posted alarms. If this number is higher than 1, after yo
displayed in the alarm bar. Pre
 Silences the audio alarm