Dillon DynaSwitch - Manual (Page 16)

16
4-3
Authorized
Replacement A. Attachment Fittings - The customer is authorized to replace only
shackle and pin attachment fittings at their facility. Customers desiring
replacement of any other attachment fitting must return the
Dynaswitch to Dillon or a factory authorized distributor for attachment
fitting replacement. The reason for this is that all attachment fittings
other than shackles and pins are pinned to the force beam after
assembly.
B. Microswitches - Addition and replacement of microswitches, as well as
conversion from one type to another is authorized as long as the user
orders the proper Dillon microswitches. Microswitch mounting brack-
ets and adjustment screw mounting brackets are available for all
authorized configurations. Switch calibration is required after such
service.
C. Other Parts - The replacement of parts other than shackle and pin
attachment fittings, authorized microswitches and microswitch mount-
ing hardware is not authorized. Attempting to make unauthorized
repairs on the Dynaswitch automatically voids the Dillon warranty.
Problems are generally limited to the Dynaswitch actuating too soon, too
late or not at all.
Recommended troubleshooting procedure:
A. Ensure there is power to the circuits involved.
B. Reset the microswitches.
C. Check the microswitch and the circuit for continuity.
D. Check the functions of the machinery setup (for items that would
cause improper actuation).
Most problems will be found in one of these areas.
Excessive wear in attachment fittings is caused by excessive loading,
improper installation or abnormal machinery travel. Replace damaged
fittings and correct the machinery installation or loading problem.
4-4
Troubleshooting