CANOGA PERKINS 2461 E1 Modem - Manual (Page 33)

EdgeAccess Universal Chassis System
2461 Modem User Manual 4-5
4.3.3 Setting Modem / SLIP / PPP Baud Rate Configuration
To configure the communication port, use the Modem / SLIP / PPP Configuration Screen:
1. From the Main Menu, type "5" and press Enter. The Utilities screen will open.
2. Type "3". The Modem / SLIP / PPP Baud Rate Configuration Screen appears:
3. The current settings will be displayed. To change them:
1. Select 1 to chose Modem/ SLIP/ PPP Baud rate
2. Select 2 to type Modem Initialization String
Note: Applies only to stand alone 2461 modem with SNMP option.
4.3.4 Specifying a Modem Initialization String
To change the modem initialization string from its default value:
1. From the Main Menu, type "5" and press Enter. The Utilities screen will open.
2. Type "4". A prompt appears for typing a new string, up to 20 characters
3. Type the string, and press enter to confirm.
Note: Applies only to stand alone 2461 modem with SNMP option.
4.3.5 Resetting the Configuration to Default Values
If you have changed the major and minor alarm, switchover or redundancy mode settings, you
can reset to the factory defaults from the Utilities screen:
1. From the Main Menu, type "5" and press Enter. The Utilities screen will open.
2. Type "5". A prompt to confirm restoring the default configuration will appear.
3. Press Enter to restore default values. The modem alarm and trap settings default will be
restored.
4. Copy configuration to other modems in the link. (See Exporting Modem Configuration
Settings section)
4.3.6 Exporting Modem Configuration Settings
To copy modem configuration settings (Switchover mode, Loopback control mode and Alarm
settings) to other modems in the links (primary and secondary, remote and local partners):
1. From the Main Menu, type "5" and press Enter. The Utilities screen will open.