C.R.Plastic Products B32 - Manual (Page 3)

Step 1: Set the Left Arm (C) flat on the floor Fig. 1. Line up Seat (B) keeping bottom edge of seat flush with
bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail V) and
attach with 6 - 1½” screws.
Figure 1
Step 2: Using Right Arm (D) to balance Back (A) Fig. 2. Line up Back (A), (detail W ). Insert 2 - 2” screws to
attach the back to the curved arm rest keeping screw holes centered on arm.
Step 3: Insert 4 - 1½” screws (detail W).
Step 4: Insert 1 – 1 ½ ” screw keeping hole centered on seat board (detail X) then
insert 2
nd
1 ½ ” screw.
Figure 2
Required Qty
Seat (B) 1
Left Arm (C) 1
1½” Screws 6
Required Qty
Back (A) 1
Right Arm (D) 1
1½” Screws 6
2” Screws 2
Keep bottom edge of seat flush
with center rail of arm.
Keep front edge of seat
back 1/8” from the
front of leg.
V
Use 1 ½ ”
Screws
Keep tight to seat.
Use 1½” Screws.
Use 2” Screws
keeping screw
holes centered
on arm.
W
X