C.R.Plastic Products C08 - Manual (Page 3)

Step 1: Set the Seat and Back legs (A) on a flat surface as shown. Using factory installed screw as a pivot,
spin the back legs out and around until the bottom edges are flush or parallel to the long angled cut.
Tighten these two screws. Put one more screw in each leg using the counter sunk holes provided.
Step 2: Place Back (E) onto the back of the Seat assembly, resting it on top of the Back Legs (A). Place a
screw through the bottom Seat Back Support into the side rail of the Seat view Y. Line up the back edge
of the Top Brace with the back edge of the back leg view X. Place a screw in the pilot hole; centre and
keep the back edge flush with the leg and fasten. Repeat for other side.
Item Drawing Qty
1 Back Assy. (E) 1
2 Screws 4
Item Drawing Qty
1 Seat Assy. (A) 1
2 Screws 2