C. Crane ATS-909X - Manual (Page 21)

Manual Tuning is accomplished using the convenient Rotary
Tuning Knob.
The Step button is used to determine the tuning spread for each
step of the Rotary Tuning Knob. Spread may be
changing accordingly:
Press and release the Step button to select the step in FAST or
SLOW mode. Press and hold Step button to stop or enable the
step in FAST or SLOW mode.
MANUAL TUNING (ROTARY TUNING)
TUNING STEP ON EACH BAND
STEP FM LW MW SW LSB/USB
STOP 0 0 0 0 0
FAST 100 kHz 9 kHz 9/10 kHz 5 kHz 1 kHz
SLOW 50 kHz 1 kHz 1 kHz 1 kHz 40 kHz
To start Auto Scan Tuning, select band to tune press one of the
Tuning Up/Down buttons for more than 0.5 second.
Once scan starts, release button. The Auto Scan stops as soon as
a station of adequate signal strength is located. Repeat operation
to start scan tuning again. Scan tuning can be halted by pressing
the Tuning Up/Down buttons momentarily any time during the
scanning process.
To manually tune to a frequency of your choice repeatedly,
press and release one of the Tuning Up/Down buttons until the
frequency desired is displayed.
AUTO/MANUAL SCAN TUNING
20 21
GB