Kidde KN-COPP-3 (900-0099) - Manual (Page 19)

17
"0" WITH FLASHING DOT NONE
NORMAL OPERATION
SENSING FOR CO
BATTERY IS FULLY CHARGED NONE
NONE
CHARGING BATTERY PACK.
INITIAL POWER UP OR
POWER WAS RESET
BATTERY DISCHARGED LESS THAN
10 HOURS ON AC, BATTERY IS IN
CHARGE STATE
KEEP UNIT ON AC TO FULLY CHARGE
BATTERY. " Lb" will disappear once
battery is charged depending on initial
charge
1 BEEP EVERY 15
SECONDS
BATTERY DISCONNECTED
OR NOT CHARGING
BATTERY DISCHARGED OR
DISCONNECTED LONGER THAN 10
HOURS
CONNECT BATTERY PACK, CONFIRM
CONNECTION IS ORIENTED AND SEATED
PROPERLY, CONTACT CUSTOMER
SERVICE
"0" ALTERNATING WITH
"Lb" AND DOT
BRIEF "888" AND
FLASHING DOT
ONE SHORT "CHIRP"
SELF TESTING ON START
UP
NORMAL OPERATION AT START-UP
OR RESET
NONE, UNIT WILL QUICKLY DISPLAY "0"
STEADY DISPLAY OF
NUMBER BETWEEN 30
AND 999
4 QUICK BEEPS, 5
SECONDS OFF,
REPEATING
CARBON MONOXIDE
DETECTED
UNIT IN ALARM CONDITION
REFER TO PAGE 13, WHAT TO DO IF
ALARM SOUNDS
STEADY "Err" AND
FLASHING DOT
"CHIRP" EVERY 30
SECONDS
NO DISPLAY CONSTANT ALARM
UNIT IS NOT OPERATIONAL,
WILL NOT DETECT
UNIT MALFUNCTION CONTACT KIDDE CUSTOMER SERVICE
Part Six – Display Readings and What They Mean
AC AND DC START UP, ALARM AND ERROR OPERATION
Pages 18-19 contain vital information about the various readings you may
see on your display. We suggest you keep this User’s Guide handy for reference.
Your new Kidde carbon monoxide alarm is a sophisticated elec-
tronic device – yet very simple to understand. Basically, the unit
will display a "0" if it senses 30 PPM of CO or less and if you
have a good backup battery pack installed.
If it senses carbon monoxide, it will display a reading so you can
see if you have a non-threatening or emergency situation. However, if the backup battery pack is low or missing, or if the
unit malfunctions, it will display other readings (and alarm differ-
ently) to alert you that something is wrong with the alarm.
Please familiarize yourself and other family members to the
difference between a CO reading and a reading signifying a
problem with the alarm itself.
Display Shows Alarm Sound Unit Status Unit Condition Recommended Action
(flashes
alternately)
If at any time you test the alarm and it does not perform as described, have it replaced immediately.
AC POWERED IN NORMAL STAND BY OPERATION
Display Shows Alarm Sound Unit Status Unit Condition Recommended Action
2507-7205-00 4/6/05 17:14 Page 19