Sangean PR-D14USB (R1) - Manual (Page 8)

7
Using the radio for the first time
Using the DC power adaptor
The DC power adaptor required for this unit should be 6 volts DC at
A. Insert the adaptor plug into the DC socket on the left hand side
of the radio. Plug the adaptor into a standard mains socket outlet.
The DC adaptor should be disconnected from the main supply
when not in use.
Operating your radio – Search tuning AM / FM
. Press the Standby button to switch on your radio.
. Press the Source button as needed until the AM or FM band is
selected.
3. Press and release the Scan button to carry out an auto-tune.
Your radio will scan up the AM / FM band from the currently displayed
frequency and will stop scanning automatically for a few seconds
when it finds a station of sufficient strength. Then it will continue
the next station search.
4. To stop the auto station search and to listen to your desired station,
press Scan button again and the unit will stop the auto tune.
5. Use the Volume control to adjust the sound level as required.
6. To switch off your radio press the Standby button.