Sangean PR-D14USB (R1) - Manual (Page 12)

Presetting stations in AM / FM mode
There are 5 preset stations each for AM and FM radio. They are
used in the same way for each waveband.
. Press the Standby button to switch on your radio.
. Press the Source button to select the desired waveband. Tune to
the require radio station as previously described.
3. Press and hold the required Preset button (1-5) until the display
shows ‘P1’ for example after the frequency. The station will be
stored using the preset number. Repeat this procedure for the
remaining presets as you wish.
4. Preset stations which have already been stored may be overwritten
by following the above procedure if required.
Recalling a preset in AM / FM mode
. Press the Standby button to switch on your radio.
2. Select the required waveband by pressing the Source button.
3. Press and release the required Preset button to cause your radio
to tune to one of the stations stored in the preset memory.