Sangean PR-D14USB (R1) - Manual (Page 16)

5
Setting the alarm clock
Your radio has two alarms which can each be set to wake you to
AM / FM radio, buzzer alarm or USB. The alarms may be se t while
the unit is in standby mode or while playing.
. Before setting an alarm ensure that the clock time is set. Press
and hold the Alarm button to enter the alarm setting.
2. The hour setting of alarm 1 will begin to flash. Press the Tuning
Up / Down to select the required alarm hour, and press and release
the Scan button to confirm the setting. Press the Tuning Up / Down
to select the required alarm minute, and press and release the
Scan button to confirm the setting.
3. Then the display will show the frequency options for the alarm.
The alarm options are as below:
ONCE- the alarm will sound once
DAILY- the alarm will sound everyday
WEEKDAY- the alarm will sound only on weekdays
WEEKEND- the alarm will sound only at weekends
Press and release the Scan button to confirm the setting.
4. Press the Tuning Up / Down to choose the required alarm type,
and then press and release the Scan button to confirm the setting.
The alarm can be buzzer, FM, AM or USB. When radio mode is
selected, the radio frequency and the preset number on the display
will begin to flash. Press the Tuning Up / Down to adjust the desired
radio frequency or preset number for the radio alarm, then press
the Scan button to confirm the setting.
Note: If USB is selected as your alarm type, but USB is not inserted
when the alarm is sounding, the buzzer alarm will be used instead.
5. The alarm setting is completed. Active alarms are shown using
alarm indicator on the display.