Sangean DDR-62 (V1) - Manual (Page 90)

89
Brightness control
The brightness of the display can be adjusted for when the radio is in Standby and for when it is
in use. If you use the unit in the bedroom, you may prefer a lower standby brightness level than
the standard setting. There are three brightness levels and an almost off 'night-time' setting.
. Press the Standby button to switch on your radio. Access the menu for the current mode by
pressing and holding the Menu button.
2. Press the Folder Up or Down buttons until 'System settings' is highlighted on the display. Press
the Select button to enter the system settings menu. Press the Folder Up or Down buttons until
'Brightness' is highlighted on the display. Press the Select button.
. To adjust the display brightness when the radio is switched on press the Folder Up or Down
buttons until 'Normal' is highlighted on the display. To adjust the display brightness when the
radio is in standby press the Folder Up or Down buttons until 'Standby' is highlighted.Press the
Select button to enter the selected brightness adjustment mode.
. To adjust the brightness level press the Folder Up button on the radio to increase the brightness
level and the Folder Down button to decrease it. The backlight level will change so that you
can see the effect of each setting. Note that the backlight is almost completely off at the zero
setting. Press the Select button to set the level. Press and hold the Menu button to exit.
When the radio is in Standby mode, pressing a button will cause the radio to switch to the Normal
brightness level for a few seconds. This is so that even if the Standby brightness level is set to
zero (almost off), it is still possible to see the time by quickly pressing a button.