Sangean DDR-62 (V1) - Manual (Page 49)

8
GB
Finding new DAB radio stations
Should you wish to use your radio for DAB reception in a new location, or if no stations were
detected during the initial scan, you can follow this procedure to allow your radio to find out which
DAB radio stations are available.
. Ensure that the telescopic antenna is extended, and then press the Radio button as needed to
select DAB radio mode.
2. Once in DAB mode press and hold the Menu button.
. Press the Folder Up or Down buttons until 'Full scan' is highlighted on the display.
. Press the Select button to initiate the scan. The display will show 'Scanning' and your radio will
perform a scan of the DAB Band III frequencies. As new stations are found the station counter
will increase and stations will be added to the list. The bar graph indicates the progress of the
scan.
5. Alternatively press the Auto button on the remote control to initiate a scan of the DAB Band III
frequencies. The Auto button may not operate in all display modes. In this case use the menu
option above.