beautypg.com

Before operation, Remote control batteries installation – Christie Digital Systems 38-VIV205-01 User Manual

Page 15

background image

15

BEFORE OPERATION

To insure safe operation, please observe following precautions :

Use (2) AA, UM3 or R06 type alkaline batteries.

Replace two batteries at same time.

Do not use a new battery with an used battery.

Avoid contact with water or liquid.

Do not expose Remote Control Unit to moisture, or heat.

Do not drop Remote Control Unit.

If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.

Danger of explosion if battery is incorrectly replaced.

Dispose of used batteries according to batteries manufacturers instructions and local rules.

Press lid down-
ward and slide it.

Remove battery
compartment lid.

Slide batteries into
compartment.

Replace compartment lid.

Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.

Remote Control Batteries Installation

1

2

3

Operating Range

Point Remote Control Unit toward
projector (Receiver Window)
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4’
(5m) and 60° in front and rear of a
projector.

16.4’
(5 m)

60°

16.4’
(5 m)

Used to adjust zoom.
(P20)

VOLUME

ON-OFF

FOCUS

ZOOM

D.ZOOM

MENU

MUTE

LASER

KEYSTONE

NO SHOW

FREEZE

AUTO PC ADJ.

IMAGE

P-TIMER

LOCK

INPUT

LENS SHIFT

MUTE BUTTON

Used to mute sound.(P21)

ZOOM BUTTON

FOCUS BUTTON

Used to adjust focus.
(P20)

NO SHOW BUTTON

Used to turn picture off.
(P21)

AUTO PC ADJ. BUTTON

Use to operate AUTO PC
Adjustment function. (P23)

VOLUME BUTTON

Used to adjust volume.
(P21)

D.ZOOM BUTTON

Used to select DIGITAL
ZOOM +/– mode and
resize image. (P29)

KEYSTONE BUTTON

Used to correct
keystone distortion.
(P20, 35)

FREEZE BUTTON

Used to freeze picture.
(P21)

IMAGE BUTTON

Used to select image
level. (P27, 32)

60°

LENS SHIFT BUTTON

Used to select LENS
SHIFT function. (P20)

WIRED REMOTE JACK

When using as Wired
Remote Control, connect
Remote Control Cable to
this jack.
Battery installation is
required when using as
Wired Remote Control.