Rane MP 44 (2001 version) - Manual (Page 9)

Manual-8
©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL (425)355-6000 FAX (425)347-7757 WEB http://www.rane.com
104535
Install the knob so that the line on the knob is properly
aligned with the silk-screening on the front panel of the
remote. Install any Decora plate of your choice. For a secured
installation, you may wish to leave the knobs off and use a
blank Decora plate to cover the remote after adjustment.
WIRE TYPES
Variations in wire type do not greatly affect the perfor-
mance of the remote controls. However, 22-gauge stranded
wire with a flexible jacket is recommended. You may use 5-
conductor unshielded remote control signal cable for shorter
runs (less than 200 ft.) or 4-conductor (2 pair) shielded
remote control signal cable (use the shield as the GND return)
for longer runs (200 to 1000 ft.). The type of wire required is
influenced by your installation and local electrical codes.
Rane Corporation does not provide or source cable. Please
contact your local retail or wholesale outlet, not the factory.
The following is a short list of suitable cable types:
CONSOLIDATED ELECTRONIC WIRE AND CABLE
Plenum cable:
Unshielded remote control signal cable CAT. # 9896
Shielded remote control signal cable CAT. #9877, CAT. #9852
WEICO WIRE & CABLE INC.
Communication and control cable:
Multiconductor, unshielded CAT. #7606
ALPHA
Communication and control cable:
Multiconductor, unshielded CAT. #1175C
BELDEN
Unshielded remote control signal cable CAT. # 88741
Shielded remote control signal cable CAT. # 88723