Rane MP 22 - Manual (Page 3)

Manual-3
12. MAIN MIC LEVEL control: This control adjusts the LEVEL of the front panel MAIN MIC Input.
13. MAIN & REMOTE MIC OVERLOAD indicator: This red LED monitors both Microphone Inputs, before and after the
MIC EQ. It lights whenever these levels exceed 4dB below clipping. Occasional flickering is normal; however, it should
not be allowed to light steadily.
14. REMOTE MIC ENGAGE switch: This pushbutton ENGAGES the REMOTE MIC Input. The adjacent red LED flashes
whenever the switch is pressed in, signalling the Remote Mic is on.
15. REMOTE MIC LEVEL control: This control adjusts the LEVEL of the rear panel REMOTE MIC Input.
16. A & B Input Channel faders: These faders control the Levels of the Input selected on each Channel.
17. CROSSFADER: This fader controls the relative level of the Inputs assigned to the A and B Channels. When this fader is at
its far left, only Channel A is heard from the Outputs. As the fader is moved toward the right, the volume of Channel B is
increased. When the fader is centered, both Channels deliver equal volume. As you might expect, at the far right only
Channel B is heard from the Outputs. The entire crossfader assembly is replaceable from the front panel without disassem-
bling the entire unit.
18. MASTER LEVEL fader: This control determines the final LEVEL at the MASTER and ZONE OUTPUTS. Unity gain is
approximately “6”.
19. HEADPHONE PAN control: This control serves two purposes. When the Headphone Mode switch (see #21) is in
STEREO mode, this controls the relative levels of the CUE and ProGraM mixed together in Stereo. When the Mode is
switched to MONO, this controls the balance between Mono CUE in the left earcup and the Mono ProGraM in the right.
20. HEADPHONE LEVEL control: Clockwise rotation of this rotary control increases the Headphone drive LEVEL.
21. HEADPHONE mode switch: In the out position, this switch feeds STEREO CUE and ProGraM to both earcups. In the in
position the headphone circuit provides MONO CUE to the Left ear and MONO ProGraM to the Right ear.
22. HEADPHONE Output jack: A ¼" tip-ring-sleeve stereo jack provides for the insertion of stereo headphones.
23. POWER “ON” indicator: This yellow LED illuminates anytime the MP 22 is connected to an appropriate power source
(see #14, rear panel).
Fader Care:
With heavy use in harsh environments, the faders may need lubrication. Rane recommends spraying one or two bursts of
CaiLube MCL into the fader. Work the fader back and forth a few times after spraying. This treatment extends longevity and
can make used faders as good as new.
Order CaiLube MCL ® from:
CAIG Laboratories, Inc.
16744 W. Bernardo Drive
San Diego CA 92127-1904
Phone 619-451-1799
Fax 619-451-2799
Web www.caig.com