Wilbur Curtis EXPR - Manual (Page 4)

4
Program Menus
Manual Dispense (Factory Default)
Press  or ► to go to Manual Dispense Select.
Press  to go to Manual Dispense Select Station.
Choose the station and press, the display will read Saving Complete! To select another station for manual dispense, press  to go
to Manual Dispense Select Station or press ► to continue to the next menu.
Dispense By Time
The next screen is Dispense By Time ◄ Select ►.
Before making this adjustment and to avoid guessing the time, run a stop watch on the time it takes to fill a cup in the
Manual Dispense mode. Use the timed results to determine your Dispense By Time setting.
Press  and all station indicator lights will flash. Select a station to program by pressing the PUSH button on your chosen sta-
tion. Screen will show the current setting (from 0.0 to 30.0 seconds, in ½ second increments). Press to ► increase the time or ◄
to decrease. To set, press  and you will exit back to Dispense by Time screen. Continue with additional selections or press ► to
continue to the next menu.
Temperature (Factory set at 190°F)
Press  and screen will show Tank Temperature. Temperature is programmable from 170°F to 204°F in 2-degree increments.
Press ◄ or ► to go up or down in degrees. Select desired temperature and then  to set. Press ► to continue to the next
menu.
Powder % Ratio
Press  and the screen will display Powder Ratio Select Station. This is shown as A, B, C, D and E, corresponding to canisters,
arranged left to right (when facing the machine), starting with A. Press desired station. Powder ratio for each canister flavor is pro-
grammable from 0% to 100%, in 5% increments.
Press ◄ or ► to increase or decrease ratio and then press  to set. Press ► to continue to the next canister. After E the screen
returns to Powder Ratio. Press ► to continue to the next menu.
Service Call (Phone number)
Press  to display number and press  change number or ► to move places and EX to exit when complete This number will be
displayed during a Heating system SENSOR ERROR or a WATER ERROR. Press ► to continue to the next menu.
Banner Name
Press  to display letters, press  to change letters or ► to move places and EX to exit when complete.
This feature allows up to 14 letters to be programmed for company name or regional name. Programming all blanks disables Ban-
ner Name. If programmed, Banner Name is displayed every 5 sec. on and off. Press ► to continue to the next menu.
Exit
Press  to select, exits program mode and returns unit to operation.