Wilbur Curtis TCT with Sweet Tea Option - Manual (Page 2)

2
CAUTION HOT LIQUID, Scalding may occur. Avoid splashing.
BREWING INSTRUCTIONS
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button) and Ready-to-Brew displayed.
2. Place filter in brew basket. Pour leaf tea into
basket.
3. Slide brew cone into brew rails. Place tea
container on brew deck.
4. Select a BREW button and press to start a
brewcycle.
Your Curtis ADS System is Factory Pre‑Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the screen.
It takes approximately 20 minutes to reach setpoint temperature of 204°F.
Control will display when temperature reaches the setpoint (204°F). Unit is now ready to brew.
SETUP STEPS
(Continued)
4 Turn on the main power switch (bottom toggle switch, behind the brewer). The heating tank will start to fill. When the water
level in the tank rises to the correct volume, the heating element will energize automatically. This eliminates the possibility of
element burnout caused by an empty tank
5. Turn OFF the sweetener pump (top switch, behind the brewer).
6. The heating tank will require 20 to 30 minutes to reach operating temperature (204°F) indicated by READY-TO-BREW on the
LCD readout.
7. Turn ON the sweetener pump at the toggle switch, behind the brewer. The pump will prime the sweetener product through the
clear tubing.
8. Run one full brewcycle, to purge the water lines and valves of air. Five seconds of dilution water at the begining of each brew-
cycle is a normal function. This is a default of the system.
9. The unit is ready for the next brew.
CURTIS
READY TO BREW
CURTIS
CURTIS
CURTIS
FILLING
CURTIS
HEATING