Wilbur Curtis TP1T - Manual (Page 8)

8
CAUTION
Do not immerse server in water.
Do not place in server dishwasher.
Do not use harsh powders or cleansers containing chlorine.
Do not use a wire brush or pot scourer to clean inside liner.
Cleaning and Sanitizing Instructions for TLXG01 Server
These cleaning and sanitizing instructions are only a guide line to be used for the cleaning and sanitizing
of the TLXG01. Your current in-house cleaning and sanitizing methods may be just as effective.
For cleaning and sanitizing of the TLXG01, the three sink method is recommended. This method consists
of a sink of water filled with a detergent and water solution, a fresh water rinse, and a sink filled with an
aqueous sanitizing solution. Immerse parts in commercial BarTabs/Sani-Tabs sanitizing solution. The solu-
tion must be warm (75°F.) Let the parts soak at least one minute.
CLEANING
Regular cleaning of the coffee brewer will maintain the highest quality coffee your equipment is capable of producing. Proper
cleaning is essential to maintain a fresh and appealing look to your coffee service. To clean the coffee brewer components, prepare
a mild solution of detergent and warm water.
1. First turn off the brewer using the ON/OFF button on the front control panel.
2. Wipe all exterior surfaces with a damp cloth, removing spills and debris.
3. Slide the brewcone out and clean it. Thoroughly wipe sprayhead area with a damp cloth.
4. Wash the brewcone. Use a soft bristled brush for hard to clean areas. Wash both parts with a detergent solution or put these
parts through a dishwasher.
CAUTION
Do not use harsh powders or cleansers containing chlorine.
1. Daily, Rinse the unit after use.
a. Open unit and empty contents completely.
b. Rinse unit with hot water, then open faucet to drain.
c. Wipe outside of unit with clean cloth moistened with cleaning solution.
2. Cleaning and server assembly.
a. Fill the unit with cleaning solution. With a sponge brush, thoroughly clean inside liner.
b. Rinse the unit using a fresh water rinse.
3. Clean and sanitize the lid assembly.
a. Remove lid from unit and submerse it in cleaning solution, cleaning thoroughly.
b. Using the supplied brush, clean inside the filling tube.
c. Rinse with clean water.
d. To sanitize, submerse in sanitizing solution for 5 minutes then air dry completely.
4. Cleaning the faucet and gauge glass.
a. Unscrew the bonnet/handle assembly from the faucet.
b. Remove gauge glass from unit and brush out with cleaning solution.
c. With the faucet removed, clean the silicone elbow fitting (Tank to Faucet Tube). Use the tube brush soaked in cleaning
solution, inserted through the faucet shank.
d. Clean and rinse parts.
e. To sanitize, place in sanitizing solution for 5 minutes, remove and air dry.
5. Sanitizing the assembled TLXG01 server.
a. Fill a clean server with sanitizing solution. Allow to sit for 5 minutes then drain through the faucet.
b. Place body assembly upside down on rack to thoroughly air dry.