Terraillon TPRO 6300 - Manual (Page 30)

30
ELECTRONIC MEDICAL SCALE CLASSE III
EN
PERSONALISATION of the body fat analysis results display (BFA)
In the factory setup, the following data is displayed: body fat, body water mass, bone mass and muscular mass.
You may choose to remove particular data from the display.
• Press and hold key [MODE] for more than 10 seconds to go into the setup mode.
• Go from the PRINT function and ID NO setup by pressing [ / Tare Height].
• The screen then displays «BFA». For each data, use keys [▲] or [▼] to select ON or OFF and thus deactivate
or activate its display. Confirm your selection by pressing key [ / Tare Height].
PRINT FORMAT FROM THE BMI BALANCE
MEASUREMENT RESULTS
ID 0001 Body fat 10 %
Age: 30 yrs Body fat 5,0 kg
Gender: Female Fat-free mass 60,0 kg
Activity Normal Body water mass 50 %
Height 175,0 cm Bone mass 4,5 kg
Weight 68,0 kg Muscle mass 20,5 kg
BMI 21,5
SPECIAL INDICATIONS
Err0 Initial zero error. Get off the scales, wait
for the display to show 0.0 and restart
the measurement.
AdErr Hardware problem. Contact your retailer.
Err1 Unstable weight: restart the weighing. EEP Hardware problem. Contact your retailer.
Err2 Overload: remove the weight
immediately.
Err3 Body impedance beyond the limit
(100 ohm to 1kohm): restart the
measurement.
If Err3 appears often and depending on
your skin type (thin or thick), it may be
necessary to moisten your feet to ensure
better contact with the electrodes.
Err4 Body fat percentage out of range 4-50%:
restart the measurement.
Err5 Water volume out of range.
Moisten your feet and restart.
bAtt Replace the battery. Ustb Unstable zero. Wait for the display to
show 0.0 and restart the measurement