Cisco SFS 7008P - Manual (Page 2)

2
Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note
78-17434-01 Rev. A0
Safety Overview
Safety Overview
Safety warnings appear throughout this publication in procedures that may harm you if performed
incorrectly. A warning symbol precedes each warning statement.
Parts List
The following items are included in your SFS 7008 package:
• Chassis with TopSpin OS v2.5.0 preloaded
•
2
Serial Cable Kits
– Serial Cable
– Serial cable document
– DB-9 connector male to RJ-45
– DB-9 connector female to RJ-45
– MX-9-1 roll-over cable
• Power cord for each power supply
• Bezel
• Parts bag
• Regulation and Compliance Statement
• 1 year warranty package (Cisco PN 83-1190-01)
Required Tools, Equipment, and Personnel
In addition to the accessories provided with the switch, you should have the following:
• A #2 Phillips screw driver
• Screws (not provided) to attach the mounting brackets to the rack
• Any associated mounting clips to secure the brackets to your rack (two for each rail of the rack)
• A rack with enough clearance for the Cisco SFS 7008P switch and cables.
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device. Statement 1071
SAVE THESE INSTRUCTIONS