Ryobi BD4600 - Manual (Page 9)

9
FEATURES
Fig.
PROdUCT SPECIFICATIONS
Belt Size ........................................................... 4 in. x 36 in.
Belt Speed ......................................................... 1,9 00 SFM
Belt Tilt ..................................................................... 0°- 90°
Disc Size ....................................................................... 6 in.
Disc Speed ............................................ 3,600 r/min. (RPM)
Table Size ............................................. 8-1/ in. x 5-3/4 in.
Table Tilt .................................................................. 0°- 45°
Input ................................ 10 V, AC only, 60 Hz, 4.3 Amps
Motor ........................................................ 1/ HP Induction
Net Weight ................................................................ 53 lbs.
4 x36
BeVel
GAuGe
Belt
tenSion
leVer
SAndinG
Belt
SAndinG
diSC
SWitCH
And
SWitCH KeY
trACKinG
KnoB
WorK
SuPPort
WorKtABle
HorizontAl
And VertiCAl
PoSition HoleS
SANdING BELT
The sanding belt can be adjusted from horizontal to vertical
providing different positions for sanding workpieces of
different shapes and sizes.
SANdING dISC
A round sanding disc is located on the side of the belt/disc
sander.
SWITCH ANd SWITCH KEy
Your belt/disc sander has an easy access power switch.
TRACKING KNOB
A tracking knob aids in centering the sanding belt.
WORK SUPPORT
Supports the workpiece on the sanding belt.
WORKTABLE
Equipped with a sturdy worktable that provides a stable
surface when using either the disc sanding or the belt
sanding feature.
KNOW yOUR BELT/dISC SANdER
See Figure 2.
The safe use of this product requires an understanding of
the information on the tool and in this operator’s manual as
well as a
knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
BELT TENSION LEVER
The belt tension lever releases the belt tension for easy belt
replacement.
BEVEL GAUGE
The worktable comes equipped with a bevel gauge that
indicates the degrees the worktable can be tilted up to 45°.
HORIZONTAL ANd VERTICAL POSITION
HOLES
The horizontal and vertical position holes are used for
changing the position of the belt from horizontal to vertical.
MITER GAUGE
The miter gauge aligns the wood for positive stops at 90°
and 45°.
Miter GAuGe