Assembly – Ryobi BD4600 User Manual
Page 13
13
4 x36
4 x36
ASSEMBLy
ASSEMBLING WORK SUPPORT
See Figure 10.
Place the work support over the holes in the side of the
tool housing.
Using a hex key, fasten in place with the washers and
socket head screws.
MOUNTING BELT/dISC SANdER TO WORK-
BENCH
See Figure 11.
If the belt/disc sander is to be used in a permanent location,
it is recommended you secure it to a workbench or other
stable surface. When mounting the belt/disc sander to a
workbench, holes should be drilled through the supporting
surface of the workbench.
Mark holes on workbench where belt/disc sander is to be
mounted using holes in the base as a template for hole
pattern.
Drill holes through workbench.
Place belt/disc sander on workbench aligning holes in
the base with holes drilled in the workbench.
Insert bolts (not included) and tighten securely with lock
washers and hex nuts (not included).
NOTE: All bolts should be inserted from the top. Install
the lock washers and hex nuts from the underside of the
workbench.
CLAMPING BELT/dISC SANdER TO WORK-
BENCH
See Figure 12.
If the belt/disc sander is to be used as a portable tool, it
is recommended you fasten it permanently to a mounting
board that can easily be clamped to a workbench or other
stable surface. The mounting board should be of sufficient
size to avoid tipping while belt/disc sander is in use. Any
good grade plywood or chipboard with a 3/4 in. thickness
is recommended.
Mark holes on board where belt/disc sander is to be
mounted using holes in the base as a template for hole
pattern.
Follow the last three steps in section
Mounting Belt/disc
Sander to Workbench.
If lag bolts are used, make sure they are long enough to
go through holes in belt/disc sander base and material the
belt/disc sander is being mounted to. If machine bolts are
used, make sure bolts are long enough to go through holes
in belt/disc sander, the material being mounted to, and the
lock washers and hex nuts.
Fig. 11
MountinG
Bolt
Fig. 10
WorK
SuPPort
SoCKet
HeAd
SCreWS
WASHerS
Fig. 1
MountinG
Bolt
HeX nut
loCK
WASHer
HeX nut
loCK
WASHer
MountinG
BoArd
C-ClAMPS