Assembly – Ryobi BD4600 User Manual
Page 12
1
4 x36
4 x36
4 x36
Fig. 6
Fig. 8
ASSEMBLy
INSTALLING SANdING dISC ANd dISC
GUARd
See Figure 6.
Unplug the belt/disc sander.
Remove the backing from the sanding disc.
Align perimeter of sanding disc with plate and press firmly
into position.
Position disc guard against the lower one-third of the
disc, aligning holes as shown in
figure 6.
Using the two phillips head screws, securely tighten the
disc guard into place.
INSTALLING/REPLACING SANdING BELT
See Figure 7.
On the smooth side of the sanding belt, there is a directional
arrow. The sanding belt must run in the direction of the
arrow.
Unplug the belt/disc sander.
Pull the belt tension lever toward you to release belt
tension.
Place the sanding belt over the drive roller and idler roller
with the directional arrows running counterclockwise. Be
sure the sanding belt is centered on both drums.
Push the belt tension lever back into place to apply the
belt tension.
NOTE: The belt tension lever is spring loaded; use
extreme caution when pushing the tension lever back
into place to avoid personal injury.
MOUNTING THE WORKTABLE FOR USE WITH
THE dISC SANdER
See Figure 8.
Unplug the belt/disc sander.
Insert the index pin into the hole as shown in figure 8.
Position the worktable no farther than 1/16 in. from the
sanding surface.
Using a hex key, tighten the hex set screw securely.
MOUNTING THE WORKTABLE FOR USE WITH
THE BELT SANdER
See Figure 9.
Unplug the belt/disc sander.
Insert the index pin into the hole as shown in figure 9.
Position the worktable no farther than 1/16 in. from the
sanding surface.
Using a hex key, tighten the hex set screw securely.
CAUTION:
To avoid trapping the workpiece or your fingers between
the table and sanding surface, the table edge should
NEVER be further from the sanding surface than 1/16 in.
diSC GuArd
SAndinG Belt
WorKtABle
Fig. 7
WorKtABle
direCtionAl
ArroW
SAndinG diSC
Fig. 9
PHilliPS HeAd
SCreWS
HeX Set
SCreW
HeX Set
SCreW
driVe
roller
idle
roller
Belt tenSion
leVer
indeX
Pin