Maintenance – Ryobi AG700 User Manual
Page 21
1
MAINTENANCE
REPLACING BRUSHES
See Figure 17.
This product has externally accessible brush assemblies
that should be periodically checked for wear.
Unplug the tool.
With a flat head screwdriver, remove the brush caps. The
brush assembly is spring loaded and will pop out when
you remove the brush cap.
Remove the brush assembly (brush and spring). Check
for wear. Replace both brushes when either has less than
1/4 in. length of carbon remaining. Do not replace one
side without replacing the other.
Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
Replace brush cap and tighten securely. Do not over-
tighten.
Fig. 17
BruSH
cAp
BruSH
cAp
BruSH
ASSemBly
BruSH
ASSemBly