Ryobi RMS10 - Manual (Page 5)

5
Fig. 2
PREPARING THE STAND
See Figure 2.

Lay the stand’s top surface down on the floor with the
folded legs on top.
 Push in a leg locking pin and rotate that leg up until the
locking pin clicks into place.
 Repeat with the remaining three legs.
 Lift the stand and place it in an upright position.
 Check to ensure the stand is stable and all the legs have
the locking pins engaged.
loCkinG
pin
leG
ASSEMBLY
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
PACKING LIST
Miter Saw Stand
Extension Rails (2)
Work Supports (2)
Adjustment Knobs (4)
Operator’s Manual