Ryobi RMS10 - Manual (Page 2)

2
RULES FOR SAFE OPERATION
Safe operation of this accessory requires that you read and
understand this operator’s manual, the operator’s manual for
the miter saw and all labels affixed to the tool.
READ ALL INSTRUCTIONS
 Know your accessory. Read the operator’s manual
carefully. Learn its applications and limitations, as
well as the specific potential hazards related to this
accessory.
 Keep the work area clean. Cluttered work areas and
work benches invite accidents.
 Always wear safety glasses with side shields.
Everyday glasses have only impact resistant lenses. They
are NOT safety glasses.
 Always confirm any miter saw used is mounted se-
curely and is stable before plugging in the miter saw.
Before turning on the saw, perform a dry run of the
cutting operation just to make sure that no problems
will occur when the cut is made.
 Do not modify or use this stand for any purpose for
which it is not intended.
 This stand is designed to be used on a flat stable
surface. Do not use the stand on an uneven surface.
Be sure to allow enough room to handle and properly
support the workpiece.
 Follow the tool mounting instructions carefully, and
ensure the tool is fastened securely.
 Maximum weight of the miter saw and workpiece
together must not exceed 150 pounds.
 Do not apply an unbalanced load that could cause the
miter saw stand to tip over.
 Save these instructions. Refer to them frequently and
use them to instruct others who may use this accessory.
If you loan someone this accessory, loan them these
instructions also to prevent misuse of the product and
possible injury.
 Rules for Safe Operation ................................................................................................................................................. 2
 Symbols ........................................................................................................................................................................... 3
 Features ........................................................................................................................................................................... 4
 Assembly ......................................................................................................................................................................4-6
 Operation ......................................................................................................................................................................... 7
 Maintenance .................................................................................................................................................................... 8
TABLE OF CONTENTS
WARNING:
This stand is designed for use with the TS1141 miter saw only. Use with any other saw can result in serious personal
injury.