Petsafe UltraSmart® In-Ground Fence™ - Manual (Page 7)

www.petsafe.net 7
Operating Guide
Install the Fence Transmitter
Place the Fence Transmitter:
• In a dry, well ventilated, protected area (1A, 1B).
• In an area where temperatures do not fall below freezing (e.g., garage, basement, shed, closet).
• At least 3 feet from large metal objects or appliances as these items may interfere with the signal
consistency (1C).
• In an area that can be accessed easily so that you can hear and respond to alarms.
1A 1B
3ft.
1C
To Install the Transmitter
1. Remove the mounting plate from the back of the transmitter by lightly depressing
the dot on the top tab and sliding the plate down (1D).
2. Using the screws provided, mount the plate to the wall within 5 feet of a standard,
grounded (3-prong) outlet.
To prevent fires and electrical hazards, install the Fence Transmitter in buildings that
are in accordance with state and local electrical codes.
1D
Charge the Receiver Collar
The Receiver Collar Charger is designed to plug into a standard AC wall
outlet and act as a charging stand for the Receiver Collar. Choose a location
close to a door that you and your dog use regularly and plug in the charger.
The Receiver Collar fits on top of the charger with the Contact Points facing
down through the holes (2A). The Receiver Collar light will glow red when
the collar is properly seated and charging. The light will turn green when
charging is complete. A built in safety circuit prevents the Receiver Collar from
overcharging.
The Receiver Collar will achieve a full charge in 2-3 hours. Each charge can last
up to three months depending on frequency of use.
2A
Do not charge your Receiver Collar every night. Frequent charging can have a negative effect on the battery. We
recommend that the Receiver Collar be used until the Receiver Indicator Light blinks yellow or red.
The Fence Transmitter includes a Collar Charge Reminder Switch that you can set to alert you to check the
collar battery status. See Step 5, page 11.
Step
1
Step
2