Petsafe Innotek Spray Bark Control Collar - Manual (Page 7)

www.petsafe.net 7
Fit the Bark Control Collar
Important: Th e proper fi t and placement of your Bark Control Collar is important for
eff ective operation.
To assure a proper fi t, please follow these steps:
1. Make sure that the Bark Control Collar is turned off .
2. Start with your dog standing comfortably.
3. Place the Bark Control Collar high on your dog’s neck close to the ears.
Center the Sensor Probe underneath your dog’s neck, touching the skin.
Make sure the INNOTEK® logo in the front of the unit is upright.
YES
NO
Note: It is sometimes necessary to trim the hair around the
Sensor Probe to make sure that contact is consistent.
4. Check the tightness of the Bark Control Collar by inserting
one fi nger between the collar and the back of the dog’s neck.
Th
e fi t should be snug but not constricting.
5. Allow your dog to wear the collar for several
minutes, then re check the fi t. Check the fi t
again as your dog becomes more comfortable
with the Bark Control Collar.
6. Trim the collar as follows:
a. Mark the desired length of the collar with a
pen. Allow for growth if your dog is young
or grows a thick winter coat.
b. Remove the Bark Control Collar from
your dog and cut off excess.
c. Before placing the Bark Control Collar
back onto your dog, seal the edge of the
cut collar by applying a fl ame along the
frayed edge.
Important: Th e Bark Control Collar should
not be worn for more than 8 hours out of
every 24-hour period.